13
Sawing.
Set upper blade guide 1/8” / 3mm above the workpiece.
Place workpiece on the table.
Plug in.
Start saw.
Cut workpiece in a single pass.
Switch OFF if no further cutting is to be done immediately afterwards.
Connecting to dust collector.
The bandsaw provides a dust port. It should be connected with the dust collector when sawing wood.
If you do not have a dedicated bandsaw extraction, there is another way to get rid of the saw dust. Most debris, except usual dust drifts,
would fall through a grate into the dust drawer. It can be easily pulled out and cleaned.
Dust port
Dust drawer
