Page 6
ProduCT sAFeTY
◊
ADDITIONAL SAFETY –
WIDE BELT SANDERS
wArning
!
Use of a wide belt sander is a source of serious injury if
basic safety rules are not followed. Be aware of the
following warnings:
◊ Pinch hazards
Be cautious when feeding a piece in the machine. Do
not place your fingers under the piece while feeding so
they could get caught between the piece and the
conveyor belt.
◊ Strangulation hazards
Do not wear loose clothing, jewelry, large gloves and tie
back long hair. They could get pinched by rotating parts
◊ Contact with rotating sandpaper
Rotating sandpaper can cause important injuries very
rapidly. Keep hands away from rotating sandpaper at all
times during operation.
◊ Kickback
A piece can be ejected by the machine and hit the
operator. Do not stand in-line with the piece when
feeding, make sure the height is adjusted with respect
to the thickness of the piece so the pressure roller
maintains proper contact, and be careful about feeding
more than one piece at the time as the thickness might
be different and the pressure roller will not hold the
thinnest piece.
◊ Minimum dimensions
Never sand pieces that are below the minimum
dimensions to avoid kickback.
◊ Material
Do not sand any material other than wood.
◊ Dust
Sanding dust represents a health hazard and must be
seriously considered. Never operate the sander without
adequate dust collection system running. Wear eye
protection. Use respiratory protection if appropriate.
Summary of Contents for TITANIUM 50-410
