Garage Controller
The controller wires to your garage door motor.
It can control up to 2 door motors.
Powermesh Indicator Status
Blue
Device is operational and ready to be set up on a network.
Use ‘add device’ in Zimi to finish setting it up.
White
Device has been set up on a network and is operational.
To set up on a different network, simply RESET the device.
Red
Device has a critical fault, try updating the firmware.
If unsuccessful, the unit will have to be replaced.
Door Position Light Ring
The light ring changes
when the door is moving.
Quick Connector
Allows for easy wiring
and simply plugs in.
See Wiring in Section 8
.
Reset Button
Press and hold to
reset the device.
Temperature &
Humidity Sensor
Do not cover the
sensor holes.
Specifications
Communication
: Bluetooth ®.
Power:
24VDC <500mA.
Outputs
: 2 x dry connect relays for
motor bell press connection.
Inputs
: 2 x Photo Eye Beams (PEB)
Refer to the compatibility list.
Door Sensor
2. Make sure the O-ring
seal is in place.
3. Insert battery with
+ symbol as shown.
1. Remove screws to take
off the back cover.
The LED light will
flash to show the
Battery Power.
Once the LED light
flashes rapidly,
release to reset.
Insert the battery
Battery test
.
Press once.
Reset the Sensor.
Press and hold
for 6 seconds.
The door sensor tracks the door position.
Each door requires a sensor.
Push button
LED light
1 2 3 4
Full
Low
Specifications
Communication
: Bluetooth ®.
IP rating
: IP66.
Battery
: CR2450.
