IF THE CAR IS NOT FITTED WITH CHILD RESTRAINT ANCHORAGE
POINTS
For Sedans only
- Drill 9mm diameter hole in the parcel shelf on the
centre line of the seating position as shown below. Before drilling the
hole, check the underside for accessibility. Install the attachment bolt
as shown below.
For vehicles other than Sedans
-
In Australia, consult your nearest child restraint fitting station or traffic
authority for vehicle inspection to find the best, correct position for
the placement of the anchorage point, and for the correct attachment
bolt length and use of spacers. In New Zealand, consult the agent for
the vehicle.
Note to Queensland purchasers: The installation of anchorage points
must be approved by authorised officers appointed by Queensland
Transport. Authorised officers can be sourced from all Queensland
Transport Customer Service and Queensland Ambulance Service
Centres.
Front of Vehicle
Attachment Bolt
Anchor fitting
Spacer(s) if
required
Vehicle metal
structure
Reinforcing
washer (cone
downwards)
Lock washer
Secure nut
UPPER ANCHORAGE FITTINGS
FOR SEDANS ONLY
Vehicle trim
Fig.2.
INSTALLATION OF CAR ANCHOR FITTING
49
Summary of Contents for 60/A/2010
Page 55: ...55...