06
03
www.britax.com.au
www.britax.com.au
PARTS LIST
A
1 x Seat
B
1 x Tray
C
2 x Leg Tubes
1. ASSEMBLy
A
To open the high chair hold the leg tube and pull
outward until the rear legs lock, you will hear a click.
B
Insert the front leg tube into the frame until the
press buttons lock. Repeat on rear leg.
2. TO SECURE yOUR ChILD
WARNING: Use this harness at all times.
A five-point harness is provided to restrain your child. To
secure the child in the harness, push buckle (A) and (B)
into the buckle housing (C) until the buckle prongs snap
into position. Carefully adjust the harness by pulling the
slider (D) until the desired snug fit is achieved in the lap,
shoulder and crotch straps. Always adjust the harness
when changing the seating position of the child. To
release the buckle, squeeze the top and bottom prongs.
A
B
B
B
CARE AND MAINTENANCE
To prolong the life of your nursery product keep it clean and do not leave it in direct
sunlight for extended periods. Trim may be cleaned using a damp sponge with soap
or mild detergent. Allow to completely dry preferably away from direct sunlight before
storing. In some climates the trims may be affected by mould and mildew. To help
prevent this occurring, do not store the product if it is damp or wet. Always store the
product in a well ventilated area. To maintain the safety of your nursery product,
check regularly and seek prompt repair for bent, torn, worn or broken parts. Use only
those parts and accessories approved by Steelcraft. Always check parts regularly for
tightness of screws and other fasteners - tighten if required.
ThIS PRODUCT IS NOT INTENDED FOR COMMERCIAL USE.
A
B
C
4000816_D FlatFold highChair.ind5-6 5-6
19/3/08 10:07:39 AM
