ST1001 6" Jointer
-29-
Calibrating Depth
Scale
4.
Using a screwdriver, adjust the scale pointer to
zero (
Figure 44
).
The depth scale on the infeed table can be calibrated
or "zeroed" if it is not correct.
Tools Needed
Qty
Straightedge .......................................................................... 1
Phillips Screwdriver ............................................................. 1
To calibrate the depth scale:
1.
DISCONNECT JOINTER FROM POWER SOURCE!
2.
Loosen the infeed table lock.
3.
Use the straightedge to help adjust the infeed
table exactly even with the outfeed table, as
shown in
Figure 43
.
Figure 43.
Infeed table even with outfeed table.
������������
������
�������
Figure 44.
Depth scale adjusted to “0” position.
8.
Rotate the cutterhead to the first knife you start-
ed with. Slightly tighten all the gib bolts, starting
in the middle and working your way to the ends
by alternating left and right (
Figure 42
). Repeat
this step on the rest of the knives.
9.
Repeat
Step 8
.
10.
Repeat
Step 8
, but final tighten each gib bolt.
—
If you used the straightedge to set the knife
heights, skip to the next step.
— If you used the knife setting jig to set the knife
heights, use the straightedge to adjust the
outfeed table height evenly with the knives
at top dead center (the highest point in their
rotation).
11.
Replace the cutterhead guard and the belt
guard.
�
�
�
�
Figure 42.
Gib bolt tightening sequence.
Scale
Pointer
Summary of Contents for ST1001
