ST1006/ST1011 8" Jointer (Mfd. Since 3/16)
-23-
28. Use the four M5-.8 x 16 Phillips head screws and
5mm flat washers to install the dust port on the
jointer stand, as shown in Figure 23.
Figure 23. Attaching dust port to jointer stand.
x 2
Recommended CFM at Dust Port: ...........400 CFM
Items Needed
Qty
Dust Collection System ...................................................... 1
Dust Hose 4" ........................................................................... 1
Hose Clamps 4" ..................................................................... 2
To connect a dust collection hose:
1. Fit a 4" dust hose over the dust port, as shown
in Figure 25, and secure it in place with a hose
clamp.
Do not confuse this CFM recommendation with the
rating of the dust collector. To determine the CFM at
the dust port, you must consider these variables: (1)
CFM rating of the dust collector, (2) hose type and
length between the dust collector and the machine,
(3) number of branches or wyes, and (4) amount of
other open lines throughout the system. Explaining
how to calculate these variables is beyond the scope
of this manual. Consult an expert or purchase a good
dust collection “how-to” book.
Dust Collection
Figure
25
. Dust hose attached to dust port.
This machine creates substantial amounts of
dust during operation. Breathing airborne dust
on a regular basis can result in permanent
respiratory illness. Reduce your risk by wearing
a respirator and capturing the dust with a dust
collection system.
Assemble the knife setting jig as shown in Figure 24.
Knife Setting Jig
Figure 24. Knife setting jig assembly.
2. Tug the hose to make sure it does not come off.
Note:
A tight fit is necessary for proper
performance.
