-46-
ST1006/ST1011 8" Jointer (Mfd. Since 3/16)
Setting Infeed Table
Height
The infeed table on the Model ST1006/ST1011 has
positive stop bolts that, when properly set up, allow
the operator to quickly adjust the infeed table
between finish/final cuts and shaping/heavy cuts.
We recommend setting the minimum depth of cut to
1
/
32
" and the maximum depth of cut to
1
/
8
" for most
operations. DO NOT exceed
1
⁄
8
" cut per pass on this
machine or kickback and serious injury may occur!
Each positive stop bolt (see Figure 66) controls the
top or bottom range of the table movement. The jam
nut locks the positive stop bolt in position so it will
not move during operation.
Figure 66. Positive stop bolts for infeed table.
Top Height
Bottom Height
Jam Nuts
Calibrating Depth
Scale
To calibrate the depth scale:
1. DISCONNECT MACHINE FROM POWER!
2. Loosen the infeed table positive stop bolts (see
Figure 66).
Straightedge
Infeed
Outfeed
Figure 67. Infeed table even with outfeed table.
3. Use a straightedge to help adjust the infeed
table exactly even with the outfeed table, as
shown in Figure 67.
Figure 68. Depth scale adjusted to “0” position.
4. Using a screwdriver, adjust the scale pointer to
“0” (see Figure 68), then reset the infeed table
positive stops.
The depth-of-cut scale can be calibrated or "zeroed"
to make sure the cutting depth shown on the scale
matches the actual cutting depth (per pass).
Tools Needed
Qty
Straightedge .......................................................................... 1
Phillips Screwdriver #2 ....................................................... 1
