ST1013 12" Jointer (Mfd. Since 3/16)
-13-
Inventory
Wood Crate (Figures 6–7)
Qty
A. Jointer Assembly ......................................................... 1
B. Fence Assembly ........................................................... 1
C. Fence Bracket ............................................................... 1
D. Push Blocks ................................................................... 2
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpacking or
they are pre-installed at the factory.
If any parts are missing, find the part number in
the back of this manual and contact Woodstock
International, Inc. at (360) 734-3482 or at
techsupport@woodstockint.com.
The following is a list of items shipped with your
machine. Before beginning setup, lay these items out
and inventory them.
Note:
If you cannot find an item on this list, carefully
check around/inside the machine and packaging mate-
rials. Often, these items get lost in packaging materials
while unpacking or they are pre-installed at the factory.
Figure 6. Crate inventory.
A
Figure 7. Component inventory.
B
D
C
Hardware (Figure 8)
Qty
E. Cap Screws M12-1.75 x 30 (Fence) ....................... 2
F. Cap Screws M10-1.5 x 25 (Pedestal) .................... 2
G. Flat Washers 12mm (Fence) .................................... 3
H. Flat Washers 10mm (Pedestal) ............................... 2
I. Lock Washers 12mm (Fence) .................................. 2
J. Lock Nut M12-1.75 (Fence) ...................................... 1
Figure 8. Assembly hardware.
J
H
E
F
G
I
