-20-
ST1013 12" Jointer (Mfd. Since 3/16)
Items Needed
Qty
Dust Collection System ...................................................... 1
Dust Hose 5" ........................................................................... 1
Hose Clamps 5" ..................................................................... 2
Recommended CFM at Dust Port: ...........615 CFM
Do not confuse this CFM recommendation with the
rating of the dust collector. To determine the CFM at
the dust port, you must consider these variables: (1)
CFM rating of the dust collector, (2) hose type and
length between the dust collector and the machine,
(3) number of branches or wyes, and (4) amount of
other open lines throughout the system. Explaining
how to calculate these variables is beyond the scope
of this manual. Consult an expert or purchase a good
dust collection “how-to” book.
Dust Collection
This machine creates substantial amounts of
dust during operation. Breathing airborne dust
on a regular basis can result in permanent
respiratory illness. Reduce your risk by wearing
a respirator and capturing the dust with a dust
collection system.
Test Run
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding setup
instructions have been performed. Operating
an improperly set up machine may result in
malfunction or unexpected results that can
lead to serious injury, death, or machine/prop-
erty damage.
Figure 20. STOP/START button locations.
STOP
Button
START
Button
To test run machine:
1. Clear all setup tools away from machine.
2. Push STOP button in (see Figure 20).
Once assembly is complete, test run the machine to
ensure it is properly connected to power and safety
components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
To connect a dust collection hose:
1. Fit a 5" dust hose over dust port (see Figure 19).
Figure 19. Dust hose attached to dust port.
2. Tug hose to make sure it does not come off.
Note:
A tight fit is necessary for proper
performance.
