ST1013 12" Jointer (Mfd. Since 3/16)
-29-
MAINTENANCE
Regular periodic maintenance on your STEELEX
®
Model
ST1013 will ensure its optimum performance.
Make a habit of inspecting your machine each time
you use it.
Check for the following conditions and repair or
replace when necessary:
•
Loose mounting bolts.
•
Worn switch.
•
Worn or damaged cords and plugs.
•
Damaged V-belt.
•
Any other condition that could hamper the safe
operation of this machine.
General
To reduce risk of shock or
accidental startup, always
disconnect machine from
power before adjustments,
maintenance, or service.
Cleaning/Protecting
Vacuum excess wood chips and sawdust, and wipe
off the remaining dust with a dry cloth. If any resin
has built up, use a resin dissolving cleaner to remove
it.
Protect the unpainted cast iron table by wiping it
clean after every use—this ensures moisture from
wood dust does not remain on bare metal surfaces.
Keep the table rust-free with regular applications of a
high-quality metal protectant.
For optimum performance from your machine, follow
this maintenance schedule and refer to any specific
instructions given in this section.
Note:
This maintenance schedule is based on average
daily usage. Adjust the maintenance schedule to match
your usage, to keep your planer running smoothly.
Daily:
•
Vacuum all dust on and around the table.
•
Clean machine and protect unpainted cast- iron.
•
Tighten loose mounting bolts.
•
Check/sharpen/replace damaged or worn
inserts (Page 32).
Every Month:
•
Check V-belt tension, damage, and wear (Page
39).
•
Clean/vacuum dust buildup from inside cabinet
and off of motor.
Schedule
Lubrication
Your jointer features bearings that are lubricated
and sealed at the factory. These bearing do not
require any further attention unless they need to be
replaced. If a bearing fails, your planer will probably
develop a noticeable rumble or vibration, which will
increase when the machine is under a load. The bear-
ings are standard sizes and can be replaced through
Woodstock.
NOTICE
Failure to follow reasonable lubrication prac-
tices as instructed in this manual for your
machine could lead to premature failure of
components and void the warranty.
V-Belts
To ensure optimum power transmission from the
motor to the cutterhead, the V-belt must be in good
condition (free from cracks, fraying and wear) and
properly aligned and tensioned (refer to the instruc-
tions on Page 39).
