ST1013 12" Jointer (Mfd. Since 3/16)
-39-
Setting Fence Stops
The fence stops simplify the task of adjusting the
fence to 45˚ inward, 90˚, and 45˚ outward (135˚).
To set 45˚ inward fence stop:
1. DISCONNECT MACHINE FROM POWER!
2. Tilt fence approximately 45° inward (see Figure
56) onto positive stop bolts, using a 45° square
as a gauge.
Figure 58. Adjusting fence to 90°.
Stop Block
Positive
Stop Bolt
Jam Nut
Figure 57. 45˚ inward positive stop bolt.
Positive
Stop
Jam Nut
To set 90˚ fence stop:
1. Lower stop block against fence, as shown in
Figure 58, and loosen fence tilt lock.
2. Tilt fence to 90° position.
3. Use a 90° square to check fence position.
4. If it is not set at exactly 90°, loosen jam nut and
adjust positive stop bolt until fence is exactly
90°, as shown above in Figure 71.
To set 45° outward fence stop:
1. Raise stop block, loosen fence tilt lock, and posi-
tion fence against 45° outward positive stop bolt
(see Figure 59).
2. If fence is not set at exactly 45˚ outward, loosen
jam nut on 45˚ outward fence positive stop bolt
(see Figure 59).
Figure 59. Adjusting fence to 45˚ outward.
Jam Nut
Positive
Stop Bolt
Figure 56. Fence adjusted 45˚ inward.
3. Loosen jam nut on 45° inward positive stop bolt
shown in Figure 57.
4. Adjust positive stop bolts (see Figure 57) until
fence is exactly 45° inward while resting on bolts
(verify angle with a 45° square).
5. Retighten jam nut (see Figure 57) loosened in
Step 2.
3. Adjust 45˚ outward positive stop bolt until fence
is exactly 45° outward while resting on bolt
(check angle with sliding bevel set to 135°).
4. Retighten jam nut loosened in Step 2.
