ST1013 12" Jointer (Mfd. Since 3/16)
-5-
Machine Features
The instructions in this manual will be easier to understand if you become familiar with the location and names of
the basic features of your new machine. Use the list below with the letters in Figure 1 to identify the 12" jointer
feature locations.
A. Outfeed Table
B. Fence
C. Fence Tilt Handle
D. Fence Tilt Lock
E. Cutterhead Guard
F. Control Panel
G. Infeed Table
H. Cutting Depth Scale
I. Infeed Table Lock
J. Infeed Table Adjustment Handwheel
K. Outfeed Table Lock
L. Dust Port
M. Outfeed Table Adjustment Handwheel
For Your Own Safety Read Instruction Manual Before Operating Jointer
a) Wear eye protection.
b) Always keep cutterhead and drive guards in place and in proper operating condition.
c) Never make jointing cuts deeper than
1
⁄
8
" or planing cuts deeper than
1
⁄
16
".
d) Always use hold-down or push blocks when jointing material narrower than 3" or surface planing
material thinner than 3".
e) Never perform jointing or planing cuts on pieces shorter than 8" in length.
Figure 1. Front view of machine.
A
B
C
D
E
F
G
H
I
J
L
M
K
