D1PRO
D1 PRO 11-2011
Operators manual for D1 PRO Drilling Machine
- 18 -
4.10 Adjusting gib clearance
The gib should not need to be adjusted often. However if the slide sticks or becomes
somewhat loose it can be adjusted as follows:
The drive and the slider (1) can be slid up and down smoothly using the lever (3),
uncovering strip (2) and the drill body.
.
Clearance adjustment should be carried out as follows:
1. loosen screws (4) after undoing the nuts (5),
2. slide the slider up and down several times,
3. slide the slider to its lowermost position
4. tighten the screws located at the height of the slider,
5. slide the slider up,
6. tighten the remaining screws,
7. slide the slider up and down and if necessary, tighten or loosen screws at the height where
problems with moving the slider occur,
8. tighten counter nuts (5) when screw has been put into position (using a hexagonal key)
Please keep all recommendation.