D1PRO
D1 PRO 11-2011
Operators manual for D1 PRO Drilling Machine
- 6 -
Safety chain can also secure the drill through
the handle
.
6) Do not use the machine in explosion hazard zones.
7) Do not start work if the machine has excessive play on guide slides.
8) Always wear safety goggles and ear protection.
9) Do not remove metal chips with bare hands.
10) Do not touch the spindle and the cutter during work.
11) Tools must be fastened firmly. When a milling cutter is used, check before start
of work if tool holding screws are fastened tightly.
12) Do not use dull or damaged cutters.
13) Do not use milling cutter without pilots, and arbors without ejection spring.
Do not touch or replace the tool with power source on – while
electromagnetic base is being used.
14) Use tools recommended in Operator’s Manual only.
15) After use, always clean metal chips and coolant from drilling machine.
16) Always unplug machine from power supply during any work on the machine.
17) Before each use the machine should be checked for the presence of damage
and the proper and consistent use. Check whether any of the parts are broken
and that all the parts are fastened properly.
Drawing 1.
Examples how safety chain should be fastened..