D2X
D2X Operator’s Manual
10
3.2. Installing, removing, and operating the annular cutter
Install the arbor as described before, wear protective gloves, and then insert the proper
pilot pin into the annular cutter
(
1
, Fig. 4). Use a clean and dry cloth to wipe the cutter.
Next, place the cutter into the arbor (
2
) in such a way to align the flats
3
with the set
screws
4
, and then use the 5 mm hex wrench to tighten both set screws.
To remove the cutter, loosen the screws
4
using the 5 mm hex wrench.
Fig. 4.
Installing the annular cutter
1
2
3
4