Rail Runner
Rail Runner Operator’s Manual
16
To control the torch via the carriage,
set the arc ignition switch to ‘I’.
Use the travel direction switch to select a direction of travel. This will start the
travel according to the parameters shown on the display. It is possible to adjust the
parameters at any time by rotating the knobs.
The produced welds form a shape similar to that shown in Fig. 6.
Fig. 6.
Graphic description of the oscillation parameters from Tab. 1
To stop the travel and save the values shown on the display, set the travel
direction switch t
o ‘O’.
After the work is finished, use the power switch to turn off the power. Then,
unplug the carriage from the power source.
If the arc ignition switch is set to
‘I’, the torch starts welding
promptly after selecting a travel direction.
Weld start
Weld end
1 /