REM + SPEAKER OUT
REM + SPEAKER OUT
BLUETOOTH
BLUETOOTH
INPUT
INPUT
OPTICAL
OPTICAL
HIGH LEVEL INPUT
HIGH LEVEL INPUT
REMOTE
REMOTE
CONTROL
CONTROL
GND
GND
+12V
+12V
FUSE
FUSE
GAIN
MIN
MAX
SUB L/ R
GAIN
MIN
MAX
RL/RR
GAIN
MIN
MAX
FL/FR
SDSP 6
ACC ON
ACC ON
AUTO ON
AUTO ON
REM + SPEAKER OUT
REM + SPEAKER OUT
BLUETOOTH
BLUETOOTH
INPUT
INPUT
OPTICAL
OPTICAL
HIGH LEVEL INPUT
HIGH LEVEL INPUT
REMOTE
REMOTE
CONTROL
CONTROL
GND
GND
+12V
+12V
FUSE
FUSE
GAIN
MIN
MAX
SUB L/ R
GAIN
MIN
MAX
RL/RR
GAIN
MIN
MAX
FL/FR
SDSP 6
ACC ON
ACC ON
AUTO ON
AUTO ON
REM + SPEAKER OUT
REM + SPEAKER OUT
BLUETOOTH
BLUETOOTH
INPUT
INPUT
OPTICAL
OPTICAL
HIGH LEVEL INPUT
HIGH LEVEL INPUT
REMOTE
REMOTE
CONTROL
CONTROL
GND
GND
+12V
+12V
FUSE
FUSE
GAIN
MIN
MAX
SUB L/ R
GAIN
MIN
MAX
RL/RR
GAIN
MIN
MAX
FL/FR
SDSP 6
ACC ON
ACC ON
AUTO ON
AUTO ON
PRODUCT BRIEF INTRODUCTION
[ 5 ]
PRODUCT BRIEF INTRODUCTION
[ 6 ]
4.2 USB signals
USB(type B)connection plug, to connect the processor to a PC and manage its funcitions
through the DSP 3 Software. The connection standard is USB 1.1/2.0 compatible.
4.3 Input - remote control outputs and power supply
1. POWER SUPPLY
.
+12V
:Positive connection terminal for car 12V power supply.
GND
:Power supply negative connection terminal(GND).
WARNING:
make sure the connection polarity is as indicated on the terminals.A misconnection.
May result in damage to the DSP. After applying power,wait at least 10 seconds
Before turning the DSP on.
5.CONNECTIONS
5.1 Power supply and remote turn on
WARNING:
to power the device,use 1 mm (16 AWG) cables.
Remark:
the DSP is intermally protected by a
Fuse-resistor soldered on its printed circuit board
To replace it contact a service center. Using an
External fuse is recommended, though it is not required.
-BATT
Ground
+ BATT +12V
16 AWG
Fuse Holder
Not Provided
Suggested Fuse
T30A-delayed
+
-
12V
Ground
2
REMOTE OUT
2. REMOTE IN-OUT
.
REM IN:input to turn on the processor remotely along with the audio signal remote Out.
REM OUT:output to turn on other devices/amplifers connected after the processor.
From the REMOTE-IN signal, the processor only takes 1second to supply the signal to the
REM OUT output. The 130-mA output current capability can also drive an automotive relay
(Making sure it does not exceed 130 mA).
