STEIN300_Hubzentriereinrichtung_HZEV_03_GB.DOC / 02.2020
21
9
Cleaning, inspection, maintenance
9.1
Cleaning
Depending on the environmental conditions of the Transport System, the belt element
and the open lift centring device will get dirty.
Clean the whole Transport System regularly. How frequently this is done will depend on
how dirty it gets.
STEIN Automation recommends cleaning the Transport System once a week.
i
Cleaning does not mean the Transport System needs to be dismantled.
DANGER
Due to the Workpiece Transport System starting unexpectedly.
DANGER
HIGH ELECTRICAL VOLTAGE!
Electric shock hazard!
1 Before carrying out any installation or repair work, disconnect the relevant
Workpiece Transport System from its electrical power supply.
2 Disconnect the workpiece transport system from its compressed air supply.
3 Put up warning signs to prevent the system from being started up while installation
and repair work is being done.
4 Remove any workpiece carriers located on the affected belt element.
Protective clothing must be worn!
When cleaning, wear goggles, safety gloves and a dust mask.
Only use a vacuum cleaner to remove dust, shavings and other particles.
5 Suction off any dust, shavings and other particles with the vacuum cleaner.
ATTENTION!
When cleaning, do not use any harsh, combustible or scouring cleaning fluids / cleaning
materials.
Avoid fluid getting into the components of the system or of the processing stations!
i
STEIN
Automation recommends the cleaner, Industrie Clean manufactured by Würth,
product number: 893140 or Arecal Clean by RECA Norm,
Article no.: 0895014500.
6 Clean dirt and lubricants from the top and bottom sides of the belt, the guide rails,
the drive shafts and the deflection shafts.
