Inserting the filter unit
1. Make sure that the dirt slots
11
are
closed before inserting the filter unit.
2. Insert the filter unit
2
into the bottom
part
3
in the correct position with the
guide lugs pointing upwards.
3. Place the top part
1
in the correct
position on the bottom part
3
. In doing
so, pay attention to the guide lugs on
the marked locking points.
4. Close all clips
12
.
The filter unit is inserted.
Placing the device in the pool and starting cleaning
CAUTION!
Risk of injury!
The device can hurt persons in the pool.
- Make sure no one is in the pool while the device is in the water.
NOTICE!
The pump of the device can be damaged if it is switched on or off
outside of the water.
- Only switch the device on or off when it is located below the
water surface.
9
2
11
3
10
1
3
12
38
