Rev. II.2017
Rev. II.2017
34
EN
message
stands for
note
Password
password mode
SCALE
scale configuration
Auto Zero range
Auto-Zero range
Manual Zero range
Manual-Zero range
Zero Track range
Zero-Tracking range
Gravity
gravity of acceleration
CaLiBRaTion
calibration
LOAD0
load0 detection
LOAD1
load1 detection
LOAD2
load2 detection
LOAD3
load3 detection
User unit
User Unit
Full Scale
Max. Cap.
1) DISPLAY
III. SCALE CONFIGURATION
ATTENTION: The parameters in Scale Configuration are closely related
to the scale’s metrology performance. It is NOT recommended to change
any parameters unless you absolutely need to. In case you´re not sure,
please contact the customer service to check if it is necessary to modify
these parameters.
33
EN
The Auto-Off function maximizes the scale’s battery life against people’s care
-
lessness not to power off the scale when it’s not working. The Auto-Off starts to
countdown timer when there’s no action or as soon as the load is stable. Any key
pressing or motion in load restarts the countdown timer.
Press
or
, and
to change the Auto-Off time.
Press
or to exit without saving. Press
or to exit and
save.
Press
or
to enter the Brightness / Backlight setup.
3) IDLE TIME
The scale displays the idle time, e.g.
, indicating 30sec.
To maximize the battery life, the scale automatically enters the Idle Mode when
there’s no action or the load is stable. In Idle Mode, the scale works in low-power
consumption status. Any key pressing or motion in load wakes up scale from Idle
Mode.
The idle time can be set to: 0 (never idle), 5sec, 15sec, 30sec, 60sec.
Press
or to exit without saving. Press
or to exit and
save.
Press
or to enter the Anti-Motion setup.
4) BACKLIGHT
The scale displays LCD backlight status. Turning off the LCD backlight saves batte
-
ry power. LCD display backlight turn on and off – 0 (backlight off), 1 (backlight on)
Press
or
, and
to change the LCD backlight
status.
Press
or to exit without saving. Press
or to exit and
save.
Press
or
to enter Auto-Off again.
For the crane scale SBS-KW-1000/10B: the scale displays LED brightness
status, e.g.
. Brightness can be set on 1 - the weakest brightness, 2 –
average brightness, 3 – the strongest brightness.
Press
or
to change the brightness level.
Press
or , to exit without saving.
Press
or , to exit and save.
Press
or , to enter Anti-Motion setup.
Press
or to enter Auto-Off again.
5) ANTI-MOTION
The scale displays the Anti-Motion level to be set, e.g.
, indicating level 1.
At the cost of measuring time, the Anti-Motion function intelligently settles the
determination of weight when the scale is in motion. The weaker Anti-Motion is,
the faster the scale displays the weight, but the longer it takes to be stable.
Anti-Motion can be set to: 0 (off), 1 (weakest), 2 (weak), 3 (normal), 4 (strong),
5 (strongest).
Press
or
, and
to change the Anti-Motion level.
Press
or to exit without saving. Press
or to exit and
save.
