6
STEINDORFF
®
2.2.1.
Installing and replacing the lamp (Figure3)
o
Please use the specified halogen Lamp 6V 30W.
1.
Hold to the bulb
①
after you wrap it with gauze or other
protection materials, then depress the plugs
②
into the jack
③
on the lamp house, ensure the filament and the bolt
④
are in a same level.
2.
Replacing the lamp when using or soon after it is turned
off, the lamp, the lamp house and nearby parts will be very
hot and will cause serious burns. Please turn the main
switch on “O” (off), pull up power plug, and make sure the
bulb, the lamp house and periphery are all cool. Then, you
can do your replacing.
Please insert the lamp gently, or it will be damaged by
excessive extrusion.
Do not touch the Halogen bulb with your hands. It will shorten
the service life or cause it to burst. If you leave fingerprints on
the surface carelessly, clean it with a dry soft cloth.
2.2.2.
Installing the condenser illumination unit (Figure 4)
1.
Insert the condenser illumination unit
①
into the bracket
②
gently, according the figure showed in the left.
2.
Turn the condenser illumination unit at clockwise about
90°, let the “AS” mark of filter holder
③
facing forwards,
and keep the screw of condenser illumination unit and the
hole of the holder in line, then screw down the bolt in the
hole with the supplied hexagon spanner.
3.
Insert aviatic BNC connector plugs
④
into aviatic BNC
connector jack
⑤
.
2.2.3.
Installing the lamp house (figure 5)
Keep the BNC connector plugs
①
and the lamp house pin
②
in
line, and keep the bolt
③
and the condenser jack
④
in line, too.
Then push the lamp house into the illumination unit gently until
they are against.
2.2.
Installing steps
Figure 3
Figure 4
Figure 5
