- move tailstock with inserted live centre close to the headstock resp. countersink of cone
- tighten clamping lever of tailstock
- loosen the clamping lever of headstock
- align the headstock to the tip of live centre in tailstock and move the quill by turning the handwheel
into the countersink of cone
- tighten quill and tighten headstock
The headstock is now adjusted correct into a “0” Position
- loosen clamping lever of tailstock and move tailstock back
-
push out the inserted “centering device” from spindle by using the long bar
ACCESSORIES, ATTACHMENTS and COPYING UNITS
All recommended and available accessories see special accessory leaflet.
Drechselzentrum Erzgebirge
Heuweg 4
09526 Olbernhau
Deutschland
Tel./Phone: +49 (0)37360-6693-0
Fax/Fax:
+49 (0)37360-6693-29
Shop
Mail:
