138
THOR 103
COD. 6909500060
STEL s.r.l.
– Via del Progresso n° 59 – 36020
Loc. Castegnero (VICENZA) - ITALY
TEL. +39 444 639525 (central.) – +39 444 639682 (comm.)
FAX +39 444 639641 – E-mail: stel @ stelgroup.it
http: www.stelgroup.it
D. erratinc or improper cutting output
1.
poor input or output connections to power supply
a. check all input and output connections
2.
current set too low at power supply
a. increase current setting
3.
torch is being moved too fast across workpiece
a. reduce cutting speed
4.
excessive oli or moisture in torch
hold 1/8 inch (3.2 mm) from clean surface while purging and abserve oil or moisture
E. no gas flow
1.
gas not connected or preassure too low
a. check source proper operating ga s preassure
2.
faulty componentes in torch and leads assembly
a. inspect torch assemblies and replace if necessary
3.
faulty components in power supply
return for repair or have qualified technician repair per serice manual
F. torch cuts but not adequately
1.
current set too low at power supply
a. increase current setting.
2.
torch is being moved too fast across workpiece
a. reduce cutting speed
3.
excesive oil or moisture in torch
hold 1/8 inch (3.2 mm) from clean surface while purging abserve oil or moisture buil-
dup ( do note activate torch)
TECHNICAL
DESCRIPTION
ENGLISH
138
THOR 103
COD. 6909500060
STEL s.r.l.
– Via del Progresso n° 59 – 36020
Loc. Castegnero (VICENZA) - ITALY
TEL. +39 444 639525 (central.) – +39 444 639682 (comm.)
FAX +39 444 639641 – E-mail: stel @ stelgroup.it
http: www.stelgroup.it
D. erratinc or improper cutting output
1.
poor input or output connections to power supply
a. check all input and output connections
2.
current set too low at power supply
a. increase current setting
3.
torch is being moved too fast across workpiece
a. reduce cutting speed
4.
excessive oli or moisture in torch
hold 1/8 inch (3.2 mm) from clean surface while purging and abserve oil or moisture
E. no gas flow
1.
gas not connected or preassure too low
a. check source proper operating ga s preassure
2.
faulty componentes in torch and leads assembly
a. inspect torch assemblies and replace if necessary
3.
faulty components in power supply
return for repair or have qualified technician repair per serice manual
F. torch cuts but not adequately
1.
current set too low at power supply
a. increase current setting.
2.
torch is being moved too fast across workpiece
a. reduce cutting speed
3.
excesive oil or moisture in torch
hold 1/8 inch (3.2 mm) from clean surface while purging abserve oil or moisture buil-
dup ( do note activate torch)
TECHNICAL
DESCRIPTION
ENGLISH
Summary of Contents for 607510000L
Page 144: ......