6945700000
accurate regulation will be possible after a few
tests).
1.
With the “SELECT MODE” button (ref.6)
select between modes: MIG 2T (ref.4) and
MIG 4T (ref.5):
MIG 2T:
in this function the arc start when the
wire goes in contact with the piece. When you
press the torch button the wire start come out
and it stops when you leave the button.
MIG 4T:
. when you press the torch button the
gas comes out ( pre gas ). When you leave
the button the wire start come out, and goes
in contact with the piece and the arc start.
Pushing again the button the arc stops and
the gas continue flowing until the torch button
is pressed. When you leave the button start
the post time pre setted.
WARNING
PREPARATION FOR MIG
WELDING IN SYNERGIC
MODE
1.
Respect the indications given previously
c o n c e r n i n g p r i m a r y c o n n e c t i o n a n d
installation.
2.
To set the welding in synergic mode press the
MODE button (ref.5 ) until to select the mig
welding mode . MIG 2T (ref.3) , MIG 4T
(ref.4);
3.
Press the TYPE button (ref.13) several times
to select the wire material . The material type
will appear on the display ;
4.
To select the wire diameter press the Ø button
( ref.11) several times until to select the size
you need ( ref.8,9,10 );
5.
To set the thickness of the material turn the
knob on the left (ref. 6 );
6.
To adjust the arc turn the knob on the right
7.
( ref.7). It is possible regulate -4V + 4Volt.
PREPARING FOR MIG
WELDING WITHOUT GAS
To use a special cored wire that allows welding
without the use of gas, proceed as follows:
1.
Check the position of the polarity changing
cable. Read the paragraph “ REVERSE
POLARITY”.
2.
Connect the earth cable to the socket of the
machine. Positive polarity ( + );
3.
Connect the torch coupling to the centralised
euro
socket of the machine. Negative polarity
( - ) ;
Now proceed as in the instructions in the
paragraph "PREPARING FOR MIG WELDING
WITH GAS".
ADVANCED SETTINGS “SET”
The default value the machine is set in MIG 2T, Fe
0,8 mm , post-gas 3 seconds and burn back
minimum. In order to change these parameters you
have to follow this sequence:
POST GAS SETTING
Press and keep pressed the button MODE ( ref.5)
for about 3 seconds until on the display you will
see SET.
14
WARNING
AVVERTENZA
AVERTISSEMENT
WARNUNG
ADVERTENCIA
PRIMA DI INIZIARE LA SALDATURA
CHIUDERE IL PORTELLO
TO OPERATE CLOSE THIS PANEL
AVANT D’UTILISER LE GENERATEUR, IL
FAUT FERMER CE PANNEAU
VOR DEM SCHWEISSEN DEN DECKEL
SCHLIESSEN
PARA UTILIZAR LA MAQUINA, CIERRE ESTE
PANEL
WARNING
AVVERTENZA
AVERTISSEMENT
WARNUNG
ADVERTENCIA
Mild Steel
AlMg5
Inox
Flux Cored ( NO GAS )
CuSi3
