6945700000
At this point press several times the button TYPE
(ref.13) to select the post gas time that you will see
on the display.
It is possible to select different values . 0,1-2-3-4
seconds.
After setting the post gas time after 4 seconds the
display will start flashing and then it will show you
again the thickness value.
BURN BACK SETTING
Press and keep pressed the button MODE (ref.5)
for about 3 seconds until on the display you will
see SET.
At this point press several times the button Ø
(ref.11) to select the Burn Back value.
The Burn back value is displayed through the
lighting of the wire diameter leds.
FACTORY DEFAULT
RESTORE
To reset the parameters to the factory values ,
keep pressed togheter the button TYPE ( ref.13)
and Ø ( ref.11) for about 3 seconds.
REVERSE POLARITY
MMA welding:
connect the ground cable to the - ( NEGATIVE )
connect the electrode holder to the + ( POSITIVE)
TIG e MIG NO GAS welding:
connect the ground cable to the + ( POSITIVE )
connect the EURO cable (Torch) to the -
( NEGATIVE)
MIG welding:
connect the ground cable to the - ( NEGATIVE )
connect the EURO cable (Torch) to the + (POSITIVE
FRONT PANEL DESCRIPTION
1
ELECTRODE led indicating mode;
2
TIG led indicating mode;
3
MIG 2T led indicating mode;
4
MIG 4T led indicating mode;
5
Welding MODE selection button
6
Amps / Thickness matial knob
7
Volts / Slope down time knob
8
Led synergic mode, wire diameter 1 mm
9
Led synergic mode, wire diameter 0,8 mm
10
Led synergic mode, wire diameter 0,6 mm
11
Wire diameter selection button
12
Digital Display
13
Material selection button
14
Led overtemperature alarm
DISPOSAL OF ELECTRICAL
AND ELECTRONIC
EQUIPMENT
Do not dispose of electrical
equipment together with normal
waste! In observance of European
Directive 2012/19/EU on Waste
Electrical and Electronic Equipment
a n d i t s i m p l e m e n t a t i o n i n
15
Burn Back default
Burn Back Medium
Burn Back Maximum
