Stell SHO 8050, General Instructions For Installation

16 – EN

IMPORTANT SAFETY INFORMATION

• 

Check the content of the package in parts list on page 2 and make sure that all parts are in order. Do not 
use damaged or faulty parts.

• 

Read all instructions before installing the equipment. When you are unsure about any part of the 
installation process, ask a professional technician for help.

• 

When tightening the screws, be careful to avoid stripping the thread.

• 

Do not install on a damp or otherwise damaged wall. The assembly material supplied in the package is 
designed to be mounted on a wall of bricks and concrete. For installation on walls made of other materials 
consult a professional.

• 

Never install or use this product if there are signs of damage.

• 

The edges of the equipment may cause injury if they are handled improperly.

• 

This device is not designed for assembly or handling by small children, or persons, who have not been 
specifi cally instructed unless supervised by a responsible person to ensure safety during handling or 
installation. Children should be supervised to ensure that they do not interfere with the equipment. 
Do not allow children to hang on the equipment or otherwise handle it. Otherwise, there is a danger of 
serious injury. Never insert your fi ngers or other objects into the mechanism of the equipment. It could 
cause personal injuries or property damage.

• 

The product contains small parts that can pose a choking hazard when inhaled or swallowed. Keep these 
parts out of reach of children!

Note: 

Specifi cations and design are subject to change due to improvements without notice.

LIST OF SUPPLIED PARTS

A

Parts for assembly of the TV set holder, screw size M4

H

Screws to assemble the holder

B

Parts for the assembly of the TV set holder, screw size 
M5

I

Nuts and washers M8

C

Parts for assembly of the TV set holder, screw size M6

J

Nuts and washers M8, Allen key

D

Parts for assembly of TV set holder, screw size M8

K

Nuts and washers M5

E

Washers

L

Wall plate, holder arm, extension bars, 
brackets

F

Spacers

M

VESA plate, cable covers, decorative 
covers and key

G

Parts to mount the holder on the wall

INSTALLATION

This TVG mount must be securely fastened to a vertical wall. If not solidly installed, it 
could fall and cause injury or damage.

Installing the mount on the wall of solid brick or concrete wall or panel

Use the wall plate, see 

Fig. 1

 to mark the placement of six holes (three in the upper row and three in the bottom 

row) on the wall. Drill the holes at least 9 cm deep using 10 mm drill. Make sure that the holes are straight and 
between two holes is always a gap at least 15 cm. Insert a plastic anchor in each hole (

G

2

). Make sure that the 

plastic anchor is entirely inserted and even with the surface of the wall. Attach the wall plate to the wall using 
6 screws (

G

1

) and six washers (

G

3

), see 

fi g. 2

.

EN – GENERAL INSTRUCTIONS FOR INSTALLATION