5
WARNING
WARNING
: High voltage. Switch off the power before installation and maintenance.
VIDEO : stelpro.com/allia
NOTE: Stelpro reserves the right to modify its product without notice to improve its operation. Therefore, the instructions in this
guide may not apply exactly to your thermostat model. Refer to the Stelpro website for the most recent documentation. Your
product, including its LCD screen, name and packaging, may also be different from the one presented in this manual.
Before you get started, take a few minutes to read this guide and watch the Allia
thermostat’s step-by-step installation video to ensure a safe and easy installation.
Before installing or using the thermostat, the homeowner and installer must read and understand
these instructions and keep them for future reference. The manufacturer will assume no responsibility
and the warranty will be void if the installer or user does not follow them. Failure to follow these
guidelines could result in property damage, injury, burns, and potentially fatal electric shock.
Electrical connections must be made by a qualified electrician in accordance with the electrical
and building codes in effect in your area.
1 -
Connect the thermostat ONLY to a 120 VAC to 240 VAC power source and respect the load limits.
2 -
Protect the heating system with appropriate circuit breakers or fuses.
3 -
Clean the thermostat regularly to remove accumulated dirt. DO NOT use liquid to clean the
ventilation openings of the thermostat.
4 -
DO NOT install the thermostat in a place where it could get wet or on an exterior wall. However,
you can install it on insulated interior walls. To avoid any risk of overheating, leave a clearance of
at least 30 cm (12 in.) around the thermostat so that it is adequately ventilated.
5 -
Also make sure not to obstruct the ventilation grilles at the bottom and top of the thermostat
housing. Clogged grilles can cause the thermostat to overheat and interfere with its operation.
