-
7
-
-
7
-
WHERE TO INSTALL YOUR MAESTRO CONTROLLER
•
THERMOSTAT
Install a MAESTRO thermostat in each room where you want to control the temperature.
You must install the thermostat at approximately 1.5 m (5 ft.) from the floor, on an
indoor wall that faces the heating system. The thermostat must be mounted on an
electrical box.
ATTENTION :
To avoid any risk of overheating, leave a clearance of at least 30 cm
(12 in.) around the thermostat to ensure proper ventilation. Also, the front of the
unit should be completely clear of any obstruction to ensure optimal functionality.
For example, do not install the thermostat behind curtains or furniture.
To avoid getting false temperature measurements, do not install the thermostat in
any of the following locations:
•
Near a window or close to a door leading outside
•
In an area exposed directly to the light or heat of the sun, a lamp, a fireplace or any other heat source
•
Near an air outlet
•
Near concealed ducts or a chimney
•
Where there is poor air flow (e.g. behind a door)
•
Where there is a high concentration of dust
•
Where there are frequent air drafts (e.g. top of stairs)
READ THIS GUIDE AND WATCH THE INSTALLATION VIDEO
Before you start, take a few minutes to carefully read this guide and watch the step-by-step video on installing the MAESTRO
thermostat. It will ensure safe and easy installation.
The installation video is at the bottom of this page:
www.stelpro.com/en-CA/maestro
