INSSTE2411014
13
remaining on the night time-switch and the current Day/Night mode. These
parameters are saved every minute if any changes are made, except for the Day/
Night mode and the remaining time left on the time-switch. These are saved only
if the Single programming mode had not been activated.
Please note that the Single programming mode is not automatically reactivated
when the thermostat is turned on. The
icon blinks to warn the user that the
mode was previously activated when the thermostat was shut off but is no longer
active. Furthermore, when power is shut off, the existing Day/Night mode is
recovered only if the Single programming mode was previously deactivated. In
the opposite case, the Day mode is automatically reactivated. The Security mode
is also reactivated if it was previously activated. However, the icon will blink for
5 minutes, during which it is possible to deactivate the Security mode by pressing
down both buttons simultaneously for 13 seconds. If this is not done, the Security
mode will remain activated and the icon will stop blinking.
night light (only for model with backlight)
You can activate the Night light option to permanently turn on the backlight. To
activate or deactivate this mode, the thermostat must first be set in Day mode.
Then, simultaneously press down both buttons for 3 seconds until the backlight
blinks. Release the buttons. The night light mode will be activated (or deactivated
if it was previously activated).
