Stelrad E-VENTO 0184B0002, User & Installation Manual

6

The 

 button allows you to adapt the

operating schedule of your device to your

needs, depending on the season, whether

your home is occupied or not.

By pressing the 

 button once or several

times, select the required mode.

Mode sequence:

SELECTING THE OPERATING MODE

Auto

Comfort

Eco

Frost protection

Mode overview

Display

•    Auto Mode

In  Automatic  Mode,  the  device  will 

automatically change from Comfort 

mode to Eco mode according to the 

established programme.

3

7 day and daily programme

Your device has been programmed and is executing Comfort and 

Eco mode orders in line with the settings and time periods you have 

selected 

(see "7 day and daily programme integrated" chapter page 8)

. 

•   Comfort mode

Non-stop Comfort mode. The device 

will operate 24 hours a day to achieve 

the temperature which has been set 

(e.g. 19°C). The Comfort mode tempe

-

rature level can be set by the user 

(see 

page 7)

.

•   Eco mode

Eco, which means the Comfort Mode 

temperature minus 3.5°C. This enables 

you to lower the temperature without 

having to reset the Comfort Mode tem-

perature. Select this mode for short-

term absences (between 2 and 24h )

and during the night.

• 

 Frost protection mode

This mode enables you to protect 

your home against the effects of cold 

weather (frozen pipes, etc.), by main

-

taining a minimum temperature of 7°C 

in it at all times. Select this mode when 

you will be away from your home for a 

long time (more than 5 days).

Important: 

the Boost mode can be enabled at any time, 

whatever the current operating mode (Auto, Comfort, Eco or 

Frost protection). 

To activate Boost mode, press 

, the desired temperature 

setting will be set at maximum for the time period you request. 

60 minutes display will flash by default.

Comment: 

if the heating indicator is switched on, the blower 

switches on and heats the room in addition to the heat emitted 

by the device.

Restoring factory settings

See page 22.

BOOST FEATURE

-  First press : Boost. 

During  the  first  minute:  the  boost  symbol  and  the  heating 

indicator appear and the duration count flash.

During the first minute, you can modify the Boost duration from 

0 to the maximal authorised duration of the Boost, such as de-

fined during the advanced settings

 (see page 15 for more de-

tails)

 by intervals of 5 minutes (or more quickly by push superior 

to 2 seconds) by pressing

and

. This modification will be 

saved and effective for the next Boost.

After 1 minute, the Boost count begins and the time is running, 

minute by minute.

Comment: 

After 1 minute, you can modify temporarily the du

-

ration:  it  will  be  valid  only  for  this  active  Boost  and  therefore 

non-recurring.

The Boost can stop for 2 different reasons:

- 

FILT

 appears on the display: 

The blower continues to operate but does not heat up. Check 

if nothing is put in front of the ventilation grid to not block the air 

flow. The filter could be full of dust, it must be cleaned 

(see page 

23)

.