9
5-
To change and/or allocate programmes press
. To exit
the setting the time and day mode, press
3 times.
Choices programmes
Schematic sequence of programmes:
Auto
Comfort
Eco
P1
P2
P3
The device is delivered by default with the self-learning mode
enabled as described
on page 7
. If this programme suits your
requirements, you have nothing more to do, the device, after
the initial 7 day learning period will follow the autoprogramme
which will continue to tailor itself to your occupancy cycles.
Programmes overview
- Auto:
Auto-programming (See Automatic programming with
selflearning process
page 10
).
- Comfort:
your device will operate in Comfort mode, 24 hours a
day, as regards each day selected.
Note:
You can set the Comfort mode temperature to the tem-
perature you require
(see the Setting the Comfort mode tem-
perature section page 7)
.
- Eco:
The device will operate 24 hours a day in Eco mode.
Note:
You can set the temperature-lowering parameters
(see
page 14)
.
- P1:
your device will operate in Comfort mode from 06:00 to
22:00 (and in Eco mode from 22:00 to 06:00).
- P2:
your device will operate in Comfort mode from 06:00 to
09:00 and from 16:00 to 22:00 (and in Eco mode from 09:00 to
16:00 and from 22:00 to 06:00).
- P3:
your device will operate in Comfort mode from 06:00 to
08:00, from 12:00 to 14:00 and from 18:00 to 23:00 (and in Eco
mode from 23:00 to 06:00, from 08:00 to 12:00 and from 14:00
to 18:00).
1-
If you just set the time and day, go to step 2.
From Auto, Comf
ort, Eco or Frost protection mode, press
for 5 seconds.
When the cursor moves above the setting time symbol ,
press
shortly.
1
3-
The two minute figures will flash.
Select using
or
.
Save by pressing
.
1
1
2
4-
The cursor above the number 1 (which represents the
Monday) will flash. Select the date using
or
.
Save by pressing
.
1
1
2
3-
With
or
, select P1.
P1 will flash. Press
for 5 seconds to make changes.
1
5 sec.
2
1
Save by pressing
.
4-
The P1 start time (which by default is 06:00) will flash.
Using
or
, you can change this time, by increments
of 30 minutes.
2
1
2-
Press
or
. The cursor moves above
prog
.
1
Potential modifications of programmes
If the default time schedules for the P1, P2 and P3 programmes
does not suit your routines, you can change them.
Modifying the P1, P2 or P3 programmes.
If you modify the time schedules for the P1, P2 or P3 programmes,
the schedules will be modified for all the days of the week for
which P1, P2 or P3 had been set.
5-
The P1 end time (which by default is 22:00) will flash. Using
or
, you can change this time, by increments of 30
minutes.
Save by pressing
.
2
1
Summary of Contents for E-VENTO 0184B0002
Page 26: ......