PP500 LED lighting controllers - User Manual
Copyright and disclaimer notice
Except as prohibited by law:
All hardware, software and documentation is provided on an ‘as is’ basis. This
information is for guidance only. Installers must perform their own risk assessment
specific to each installation.
It is essential that the user ensures that the operation of the product is suitable for their
application.
The user must ensure that incorrect functioning of this equipment cannot cause any
dangerous situation or significant financial loss to occur.
Deliberate acts of endangerment and vandalism are not covered by this document and
must be considered by the installer.
While care has been taken in the preparation of this document Gardasoft Vision Ltd will
not accept any liability for consequential loss of any kind except those required by law.
All trademarks acknowledged. Hardware, software and documentation are
Copyright 2002 – 2018 Gardasoft Vision Ltd.
EC conformity declaration
The EC Certificate of Conformity is available from Gardasoft Vision Ltd on request
Issue status of this document: Issue 020 (January 2018)
PP500 LED lighting controllers - User Manual
Contents
1
Getting started
5
2
Safety
6
2.1
Heat
6
2.2
Electrical
6
2.3
General
7
2.4
Installation guidance (disclaimer)
7
3
Sicherheit
8
3.1
Wärme
8
3.2
Elektrik
8
3.3
Allgemein
9
3.4
Installationsanleitung (Haftungsausschluss)
10
4
Sécurité
11
4.1
Chaleur
11
4.2
Électricité
11
4.3
Généralités
12
4.4
Guide d'installation (clause de non-responsabilité)
13
5
General description
14
5.1
Output modes
14
5.1.1
Continuous
14
5.1.2
Pulsed
14
5.1.3
Switched
15
5.2
Triggers
15
5.3
Flags
15
5.4
Automatic light sensing
15
5.5
Cold start
15
6
Mechanical fixing
16
7
PP500 heat output
18
7.1
Heat output per channel
18
7.2
Total heat output
18
8
Connections
20
8.1
Triggers
20
8.2
Power supply
21
8.3
Wiring
21
9
Front panel configuration
22
9.1
Startup
22
9.2
Setting the light rating
22
9.3
Setting up continuous output
23
9.4
Setting up switched output
24
9.5
Setting up pulsed operation
25
9.6
Setting pulse delay and width times
27
10
Reference information
30
10.1
Timings
30
10.2
Specifications
30
10.3
Error codes
31
WWW.STEMMER-IMAGING.COM
