www.vingtor.com
STENTOFON and VINGTOR products are developed and marketed by Zenitel Norway AS. The company’s Quality Assurance System is certified to meet the requirements in NS-EN ISO 9001:2002.
Zenitel Norway AS reserves the right to modify designs and alter specifications without prior notice, in pursuance of a policy of continuous improvement. © 2009 Zenitel Norway AS.
support@vingtor.com
DOC NO
GB - 9 - MI 23614 v.1.2
2009-09-01
Route the cradle cable through the opening and secure with a cable clamp.
Connect the 4-pin plug to P9 and the 2-pin plug to P10.
Open the solder-split A to activate the reed switch.
Close the solder-split N1 to set the handset microphone level.
The station will switch to low-speaking mode on lifting handset.
•
Headset with microphone, LBB 7026/83
A headset with microphone is available as an alternative to the normal handset..
An optional switch will toggle between high- and low speaking mode.
●
Further instructions are found in manual MI 24413.
external microphone, LBB 7026/73
A freestanding microphone with flexible mounting may substitute the built-in microphone where the distance to the opera-
tor’s unit is too far.
This microphone is plugged into connector P4.
●
Further instructions are found in manual MI 23914.
AdJuStmentS
The volume in the operator’s unit and on the public side can
be adjusted individually without opening the station.
The volume controls are accessed by means of a small
screwdriver through an opening under the station. The
potentiometers are clearly marked.
Adjust the sound volume to a suitable level on both
sides of the partition.
Simplex mode Setting
By default the station is set for duplex operation with the possibility to force the speech direction towards the public side
amplified by +6 dB. Solder split N4 is closed on delivery.
It is possible to set the system to push-to-talk / release-to-listen simplex mode with normal amplification both ways.
•
Open solder split N4 situated in the middle of the station board.
