18
5 T
ECHNICAL
S
PECIFICATIONS
5.1 D
IMENSIONS AND
W
EIGHT OF THE
S
PINDLE
-
Length:
130 mm
-
Diameter:
52 mm
-
Weight:
0.65 kg
-
Clamping neck:
43 mm (Euro neck)
-
Cable length:
approx. 2 m / 6 feet
5.2 O
THER
C
HARACTERISTICS OF THE
S
PINDLE
-
Collet diameter:
ER11, max. 8.0 mm
-
Housing:
Aluminum 7075 anodized,
-
Type of the engine:
Three-phase asynchronous engine
-
Speed range:
3000-20000 rpm, clockwise rotation (15 – 100%)
-
Electronic control:
Governor electronic to provide maximum torque at all speeds
-
Maximum voltage:
24 V
-
Maximum current:
14.6 A / 20.8 A
-
Maximum torque:
0.17 Nm / Nm 0.25
-
Maximum cutting force (Ø 2mm):
163 N / 240 N
-
Maximum performance:
350 W / 500 W
-
Type and number of ball bearings:
Steel, lubricated for life, 3x
-
Run-out in the clamping taper in mm:
<0.01
-
Cooling:
Labyrinth air cooling
-
Additional features:
Shaft lock button
5.3 P
IN
A
SSIGNMENT OF THE
I
NTERFACE
(15-
PIN
D-
SUB
I
NPUT
S
IGNALS
)
Pin number
Function
Pin number
Function
1
Not used
9
Not used
2
GND (mass)
10
GND (mass)
3
Not used
11
Not used
4
Not used
12
Not used
5
Not used
13
Spindle on / off
6
Not used
14
Not used
7
PWM Signal
(0-5V)
15
Not used
8
Not used
---
---
5.4 S
PARE
P
ARTS
All parts of the spindle and the controller can be purchased separately.
Our contact details can be found on the front page of this manual.
6 T
RANSPORT
/
S
TORAGE
6.1 T
RANSPORT
Please make sure that the spindle is not exposed to heavy shocks during transport. This can lead to unwanted
vibrations. If necessary, transport the device in suitable containers.
6.2 P
ACKAGING
If you do not want to re-use the packaging material of the spindle and the control unit, remove it properly and
according to disposal conditions at the site and carry it to the recycling or disposal unit.
