Tech Support:
consumer.steppir.com/support | 425.453.1910 | support@steppir.com
3
Operate Only Within an EMC Chamber
Under normal operations, this system emits high levels of RF radiation. The system is intended to be used in
an EMC chamber only to prevent personal injury or damage to instruments.
Maintain a Proper Distance Between Antenna Elements and Conductive Surfaces
High voltages on the elements can occur when operating the antenna with an amplifier. All conductive
surfaces, such as the walls, ceiling, or floor of the EMC chamber, should be kept at least
15” (38
cm) from the
antenna elements to avoid arcing.
Observe Antenna Power Ratings
The SY3 antenna is rated to 2500 Watts at 2.5:1 VSWR. Operating at higher wattage or higher VSWR values
can result in damage to the system.
Burn Prevention
The SY3 Antenna enclosure underside surface may be hot during and immediately after transmitting. Use
caution when handling the device to avoid burns.
Trip Hazard
The system components are connected via long lengths of cable. Use caution when moving between
components to avoid tripping and causing personal injury or damage to the equipment.
Handling Safety
Please handle with care during transportation to avoid tipping or dropping the system components to avoid
personal injury or damage to the equipment.
This product is intended to be used and operated exclusively within an EMC chamber by
trained professionals. If the product is used in a manner not specified by the manufacturer
the protection may be impaired.
GENERAL SAFETY SUMMARY
