Steren DRON-020, Manual

19

DRON-020

Before to use the product, please read carefully this manual to avoid any malfunction.

The info in this manual is shown as reference. Because to updates may exist differences. Consult our 

website www.steren.com to obtain the most actual version of this manual.

CAUTIONS AND GENERAL RECOMMENDATIONS

Is very important that the user follow the recommendations and cautions. Steren is not responsible by 
materials damages or personal injuries caused by ignoring the cautions or by wrong use.

• This device should NOT be used by kids under 14 years

• The kids must used this product under the adult supervision.

• Always have an eye on the drone, to avoid damages to people or pets.

• Don’t touch the propellers while working.

• Be careful with the manipulation of the battery may be hot.

• Don’t use the drone with bad weather (rain, strong wind or electric storm).

• Keep away from high tension cables, trees, buildings or others dangerous areas.

• Avoid strong drops, may cause damages.

• This device cannot be used by people with different abilities,  unless they have preparation and

supervision.

• Don’t try open the device, may cause malfunction and the warranty will be avoid.

• If the battery is hot, leave it some minutes to dry before  using again.

• Use the included charger only.

• Be sure that battery connector is in the right position before to insert it into the drone. Never force the

connections.

• Don’t pull the battery cables; manipulate carefully to avoid damages in the connections.

• If the battery is damaged, you must not use immediately.

• Don’t pull the camera cables; manipulate carefully to avoid damages in the connections.

• Choose an open area to operate the drone.

• Leave at less a distance of 1.5 m between you and the drone.

• Always turn off the drone and disconnect the battery.

The operation of this equipment is subject to the following two conditions: (1) it is possible that 

this equipment or device may not cause harmful interference and (2) this equipment or device 
must accept any interference, including interference that may cause undesired operation.