Steren RM-12, User Manual

ENGLISH

ENGLISH-3

1.- Turn on the device that you want to program.
2.- Press the button which correspond to the device  to be 
programmed. In the screen you will see the selected device.
3.- Press and hold SET for 3 seconds, in the screen you will see 
the message CODE SETUP.
4.- Press SELECT . Find the code for your device in the codes 
list and enter the 3 digits code. 
5.- If the code is correct, the screen will show the message 
Success.
6.- Now aims the remote control at your device, and press 
POWER. If your device switch on, you are ready to operate the 
device. Watch and keep that your device works properly with 
the remote control. If your device does not respond or is not 
functioning properly, please try with each code listed for your 
brand, repeating from step 2 to 5. If it’s necessary, try the Search 
Method.

Do not use more than 10 seconds to press a button in each 
step, otherwise you’ll leave the program mode and you must 
start the process, again.
Probably there are more than one code for your device, but 
only one of them will control almost the total of functions, 
try to 

fi

 nd the more appropriated code for your brand.

SEARCH METHOD

1.- Be sure the device to be programmed is ON, not in Stand-By.
2.- Press the button of the desired device in the remote 
controller. In the LCD screen you will see the selected device 
name.
3.- Press and hold SET for 3 seconds, CODE SETUP message 
displays in the screen.
4.- Use the multi-control button to choose CODE SRCH option.
5.- Press SELECT to con

fi

 rm the option.

6.- Aim the remote controller to the desired device while use 
Search Method.
7.- Move the multi-control button, Up or Down, to see different 
codes in the screen.
8.- When your device turns off, press SELECT to choose the 
right code.
9.- Press POWER once again in the remote controller in order to 
check if your device turns on. Test the remote control functions, it 
must control almost the functions, otherwise repeat the 
instructions.

Do not use more than 10 seconds to press a button in each
step, otherwise you’ll leave the program mode and you must
start the process, again.
Probably there are more than one code for your device, but 
only one of them will control almost the total of functions, 
try to 

fi

 nd the more appropriated code for your brand.