Arpeggiator_____________________________________________________________________________________________15
9. Arpeggiator
This chapter handles the Programmers mode for editing the Pulse's arpeggiator. The Programmer itself does not
offer any arpeggiator.
You surely did not miss the dedicated ARP buttons on the Programmer. You can use them to switch the Pulse's
arpeggiator modes to ON or HOLD. Pressing it again switches the Arpeggiator OFF again. Pressing the other key
while Arp is on, the mode will be changed from ON to HOLD or vice versa.
The Arpeggiator parameters are saved with the program. It is not unlikely a program has it's Arpeggiator mode
set to ON or HOLD. This will be recognized by the Programmer on incoming dumps or manual requests. You see
at any time the current state of the arpeggiator.
Arpeggiator Setup
Now you want to change the Arpeggiator settings. Hold one
of the 2 buttons for 2 seconds and enter Arpeggiator setup.
The Programmer's Display will show something like the
picture to the right side.
On entering Setup with the ON button, the Arpeggiator will
automatically be set to ON, similar when using HOLD to enter
setup.
Use the Encoders to conveniently change the parameters.
The function of the 4 parameters with all their values are
described in the Pulse manual.
Note: Arpeggiator setup is not accessible until Programmer and
Pulse are in sync.
Synth Programmer for Waldorf Pulse – Operation manual V 1.0 – 01/2018
© Stereoping Germany, Meschede 2018
