THERMOMETER & THERMOSTAT
The bi-metal thermostat is used to adjust the temperature of the sterilizer. The
glass thermometer on the front of the unit indicates the
sterilizer’s chamber
temperature.
PILOT LIGHTS
The sterilizer has two (2) pilot lights. The left light will be on as long as the time
switch is in the
“ON” position. The right light is on only while the heating elements
are operating and heating the sterilization chamber.
REPLACEMENT FUSES
Models 200 & 300: Slow Blow type, rated 10A, 250V Models 200 & 300
(230V): Slow Blow type, rated 5A, 250V
The fuse is located on the right side of the unit, next to the power cord.
CLEANING AND MAINTENANCE
Clean the inside and outside of the sterilizer with a stainless steel cleaner at least
once a month. We recommend Cleaning Kit #201009. When cleaning the inside of
the chamber, spray cleaner on cloth first and avoid contact with heating elements.
Use a wet cloth to wipe away any cleaner residue and then follow with a dry cloth
to wipe dry.
Replace the inner door gasket once a year, or sooner if it becomes loose. Order
gasket # 201108 for Model 200 or #301108 for Model 300. Replace the thermostat if
the temperature control becomes erratic or every 3 years. Order part #201032 for
Model 200 or part #301032 for Model 300.
ENVIRONMENTAL CONDITIONS
The Steri-Dent sterilizer is designed for indoor use with the following conditions:
• Temperature Range of 5°C to 40°C (41°F to 104°F)
• Maximum Relative Humidity of 80% up to 31°C (88°F).
Decreasing linearly to 50% at 40°C (104°F).
• Pollution Degree 2 applies in accordance with IE 664.
• Transient Over-voltage Category II applies.
• Supply voltage not to fluctuate more than 10% (+/-12V at 120V, +/-22V at 220V)
• Maximum altitude of 2000 m (6562 ft).
Steri-Dent sterilizers are the result of a design that has been in use for many
years by dentists, hospitals, and the U.S. armed forces. This design has been
refined and improved over the years to make it safe and simple to operate, easy
to use, and low in cost to operate. It is user friendly and very reliable, but
requires the operator to choose the proper loading, temperature and time
settings to ensure complete sterilization.
ETL LISTED
CONFORMS TO UL STD 61010-1 CERTIFIED TO
CSA STD C22.2 NO. 61010-1 CAN/CSA STD
C22.2 NO 61010-2-040
FDA 510(K) K771070
CPAC Equipment, Inc.
2364 Leicester Road, Leicester, NY 14481
Phone (585) 382-3223 · Fax (585) 382-9481 ·
www.cpac.com
OPERATING INSTRUCTIONS
MODELS 200 AND 300
SAVE THESE INSTRUCTIONS
12/16
