202558
COVANA III ‐ Revision 5
14
UNCRATING THE COVANA
1. Stand the Covana in the vertical position, ensure wind conditions allow for this to be done safely
2. Remove the hardware box and sort the hardware
3. Using the screwdriver bit included in the hardware kit, remove the lower corner braces of the crate
4. Remove the four screws on the metal cover of the operator
5. Remove the six screws that fix the bottom feet of the four posts to the crate
6. Using a 7/32” Allen wrench loosen the bolts in the
center of the post top plates, no more than five
turns.
7. Remove the two single posts out of the shipping
bracket and carefully lay posts on the ground.
Bend the brackets up and out of the way.
8. With the help of one other person remove the
motor end post assembly out of the crate. We
recommend one hand under the main frame and
one holding the post vertical. Handle and carry the
assembly so that the posts are straight and
parallel. DO NOT TWIST.
9. Remove all of the frame pieces at the
bottom of the crate.
10.Lower the crate down in the horizontal
position, remove the wrapping from the
sides and disassemble the crate. Six
screws per side, three top and three
bottom. See arrows below
11.
BE AWARE
that the square drive shafts
are hidden in the bottom of the crate
directly under the roof, remove before
discarding the crate
Summary of Contents for COVANA
Page 2: ...202558 COVANA III Revision 5 2 La version française du manuel débute à la page 21 FRANÇAIS ...
Page 8: ...202558 COVANA III Revision 5 8 FRAME DIMENSIONS AND FOOTPRINT ...
Page 12: ...202558 COVANA III Revision 5 12 Wiring Schematic Diagram 120VAC 60Hz Operator North America ...
Page 13: ...202558 COVANA III Revision 5 13 Wiring Schematic Diagram 220VAC 50Hz Operator Europe Only ...
