6
7
FAucET INSTAllATIoN
STEP 3 – coNNEcTINg ThE WATER SuPPly
1
Connect the flexible pipe to the water
supply.
For models with temperature control
connect the red flexible pipe to the
hot water supply and the blue flexible
pipe to the cold water supply.
Make sure the filter (s) is installed
between the flexible hose (s) and
the shut off valve (angle valve - not
supplied).
2
Turn on the central water supply and
the shut-off valves (angle valves) and
check for leaks.
STEP 4 – coNNEcTINg ThE PoWER SouRcE
1
If your model is Swan 1010 \ Swan 1000:
your product contains an internally mounted
9V battery. To activate it, proceed to clause # 2.
If your model is Swan 1010 B \
Swan 1000 B:
install the battery
box underneath the sink with the
cable connection pointing down and
connect the connectors.
If your model is Swan 1010 E \ Swan
1000 E:
Plug the transformer into the
electricity socket and connect the
connectors.
2
Remove the protective sticker from the
sensor
3
Wait a few seconds before activating the
faucet. If the range is unsatisfactory, refer to
the section titled “Settings adjustment”.
15
SECONDS
ABOUT
FAucET INSTAllATIoN
1 INLET VERSION
2 INLETS VERSION
