12
13
InsTALLATIon
4
remove the 2 locking screws located on
either side of the motor unit using Allen
key supplied.
5
remove the cover of the motor unit.
Note: To connect a hardwire cable or to change the existing power cable, See relevant
section below.
6
Position unit at the end of the air hose.
connect the unit firmly to the wall.
note: hose length can not be cut.
note: make sure the bottom of the unit
has a clearing of a minimum 10 cm (4”)
from any obsticle.
Connect to
the wall
7
Attach the connector.
8
Please note that since the connector is
water proof, some friction might apply.
1. O-rINg vISIBLE –NOT cONNEcTED PrOPErLY
2. ONLY THE grOOvES ArE vISIBLE – cONNEcTED
PrOPErLY
1.
2.
9
reassemble cover, knob, filter housing.
connect the electricity (cable not
included).
InsTALLATIon
oPeRATIng THe HAnd dRyeR
Before proceeding, check that no objects are in
front of the sensor aside from the washbasin.
OBJECT
1
remove the sticker covering the
sensor eye wait 15 seconds for the
sensor to set up.
2
Activate the hand dryer by placing hand below the sensor unit
remove hands when finished drying.
3
Air power can be increased or
decreased by adjusting the power
selector knob located on the motor
unit.
ConneCTIng oPen wIRe CABLes (noT PRovIded)
1
Loosen the screws to remove the
exising cable.
Loosen the screws
remove and connect
L N g
2
connect the hardwire cable.
CHAngIng THe CABLe
1
Loosen the screws to remove the
exising cable.
Loosen the screws
remove and connect
L N g
2
connect the the preferred cable.
