6
7
FIllIng the soaP tank
settIngs adJustment wIth
a Remote contRol
lIquId soaP dIsPenseR
1
Unscrew the soap tank from the pump assembly and
pull it out from the bottle support.
2
Fill the bottle with liquid soap to the top line. Make
sure the bottle is clean before filling it with soap.
3
insert the bottle back into the bottle support.
4
Screw the soap tank back into the pump assembly.
Make sure the tank is firmly secured into place.
5
press and hold the refill button located at the back of
the pump assembly until soap is dispensed from the
soap dispenser spout.
release the button once soap begins dispensing from
the spout.
Alternately, use the FiLL function on the remote control
(if available). see page 14/15.
note: When the soap in the soap tank reaches the
bottom line, the tank needs to be refilled.
To refill the soap tank please refer to steps 1-5.
if available, the soap dispenser remote control can adjust the dispenser’s settings. To
use the remote control hold it in front of the sensor at a distance of 10-15cm (4-6”).
Attention: The remote control will not operate out of the recommended range (too
close or too far).
The remote control can be used to adjust the following functions:
1-soaP quantItY
The 1-4 drop keys allow the user to choose the desired soap quantity.
4
2.1 to 2.3 cc *
3
1.6 to 1.9 cc
2
1.2 to 1.6 cc
1
0.7 to 0.9cc
Indication: continuous blinking of the light in the sensor eye.
2
3
1
4
2-adJ
This function resets the sensor back to factory
settings.
Indication: 2 blinks of the light in the sensor eye.
3-temPoRaRY oFF FunctIon
This function temporary disables the
dispenser. Use this function to preform
maintenance in front of the sensor without
activating the system (for example: cleaning).
The soap dispenser will shut off for one minute
after this button is pressed once.
To return to normal operation before the
minute is over, press the On/Off button again.
Indication: OFF – 2 fast blinks, ON – 4 fast blinks
4-FIll the soaP tank
Once the soap tank has been filled \ refilled,
press the FiLL button. The pump will run for one
minute, priming the piping with soap. Once
soap begins dispensing from the spout, priming
is complete. press the FiLL button again to stop
the priming before the minute is over.
indication: continuous solid light in the sensor
eye.
if your model is an MF model, please refer to the Multifeed installation guide.
Summary of Contents for 280200
Page 10: ...16 17 ...