8
INSTALLATION
Tubular Soap Dispenser 2030 B / E
Quadrat Soap Dispenser 2030 B / E
Step 1 – Preparing for installation
1. Disconnect the soap dispenser body
with the rosette by unscrewing the set
screw.
2. Cut an adequate opening in the
wall for the dimensions of the soap
dispenser base (where you want to
install the spout), and the corrugated
tube.
SET SCREW
Step 2 – Installing the soap dispenser
1. Mount the soap dispenser base to
the opening cut in the wall, and set it
using the two small anchors provided.
Important:
The soap dispenser base
should be installed so that the outside
surface of the finished wall falls
between the minimum and maximum
lines marked at the base.
2. Assemble the temporary protective
soap dispenser base cover.
