Stern Extreme CS B, Installation And Maintenance Manual

6

7

INsTallaTIoN

INsTallaTIoN

EXTrEmE cs DPE/DP b

SteP 2 – CoNNeCtING tHe wAter SUPPLy

∙ remove the plastic tip that is inserted in the end    

   of the black flexible tube.

∙ Connect the dual power box to the water supply    

    lines.

∙ Connect the black flexible tube to the quick 

    connector on the top of the dual power box.

∙ Place battery into the Dual Power input box.

SteP 3 – CoNNeCtING tHe Power SoUrCe

1

Turn on the central water supply. Check for leaks. 
Remove the protective sticker from the sensor.

2

Connect the power source.

3

Once the power source is connected, 

wait  15 seconds to allow the system 

to set the ideal sensor range. A LED 

will flash continously to indicate this 

adjustment period. The solenoid valve 

will open for 1 second to indicate that 

the ideal sensor range was set.

15 

SECONDS

2

If the automatically adjusted sensor range is not satisfactory to your purposes, 

please refer to the section entitled “Settings adjustment”.

SteP 1 – INStALLING tHe FAUCet 

1

shut off the water supply.

2

Cut an adequate sized hole in the wall for the dimensions of the faucet 

base (see Technical Data).

3

Install the faucet base firmly to the 

roughing wall.

4

Attach the temporary protective cover 

over the faucet base.

NoTE

: Make sure that the corrugated tube outlet remains outside of the wall 

during tiling. Access is needed after the completion fo the wall.

5

Once the electrical, plumbing and tile work is complete cut off the 

temporary faucet base cover. Then slide the rosette on the base of the 

faucet.

6

Pass the four pin connector and the black flexible tube (connected to the 

faucet head) through the base of the faucet until they can be accessed 

from the opposite side of the corrugated green tube.

7

Place the faucet on the base and secure it with the set screw on the bottom.