Stern Extreme CS B, Installation And Maintenance Manual

8

9

sETTINGs aDjusTmENT 

sETTINGs aDjusTmENT 

adjusting the settings with the remote control

If necessary, the sensor settings can be adjusted as following:
Shut off the water supply. In order to adjust the sensor with the remote control, hold 

the remote control straight in front of the sensor in a distance of about 6-8” (15-20cm). 

Choose the function you want to adjust by pressing once on one of the function buttons. 

After pressing once on a specific function button, a quick flashing of the LED at the 

front of the sensor will occur. At this stage, you can change the setting by pressing the 

(+) or the (-) buttons, every push will increase or decrease one level. After finishing the 

adjustment, turn the water supply back on. 

DETECTION 

RANGE 

DELAY IN TIME

SECURITY TIME 

COMFORT FLUSH

DELAY OUT TIME 

TEMPORARY OFF 

FUNCTION 

RESET

SELF ADJUSTMENT 

MODE

HYGIENE FLUSH

DETEcTIoN raNGE:

This faucet was supplied with a self 

adjusting sensor. The ideal detection range for the specific 

location will be set automatically. 
Only if necessary, use the remote control to adjust the sensor 

range as follows:
Press the RANGE button. Wait until a quick flashing of the LED in 

the sensor eye is perceived. Then, press + to increase the range 

and – to reduce it. Every push will increase or decrease one level. 

note: 

Once you have changed the detection range with the remote control, 

the distance will be remembered by the sensor, even if the power source is 

disconnected. To get back to the self adjustment mode, use the ADJ button only.

entRance to the selF adjustment mode:  

Check that no 

objects are in front of the sensor. Press the ADJ button. Once a 

quick flashing of the LED of the sensor eye is perceived, remove 

your hand holding the remote control and move away from the 

sensor area. The ideal sensor range for the specific location will 

be set automatically. Once the self adjustment has taken place, 

the solenoid valve will be opened and closed for 1 second as an 

indication that the ideal sensor range was set and the product is 

ready for use. 

secuRIty tIme: 

The Security time, prevents continuous running 

of water due to reflections or vandalism. By default, if the sensor 

is covered for more than 90 seconds the water flow will shut 

automatically. To resume regular operation any obstruction must 

be removed.
Press the SEC button. Wait until a quick flashing of the LED in the 

sensor eye is perceived. Then, press + to increase the security 

time and – to reduce it.