CAUSES
SOLUTIONS
The handle is not
correctly fitted
PROBLEMS
The panel bolts are
not correctly inserted
Adjust the height of the handle
and check that the panel bolts
are correctly inserted
The quick-fastening levers
are not tightened
Tighten them
The mower does not start
The battery charge is low
Recharge the battery
The battery no longer holds
its charge or no longer works
Change the battery
The mower cuts unevenly
The grass is not uniform
or thick, or the cutting height
was not correctly adjusted
Check the height of the wheels.
All the wheels must be set
to the same cutting height
so that the mower can cut
evenly
Mulching is not
done correctly
The grass cuttings are damp
and sticking to the mower
Wait for the lawn to dry
before mowing
The mower is difficult
to push
The grass is long, the rear
panel of the mower and the
blade are dragging in very
dense grass, or the cutting
height is set too low
Raise the cutting height
The grass cuttings are
not collected properly
in the grass box
The cutting height is too low
Raise the cutting height
The mower vibrates
at high speed
The blade is out of balance
or worn
Change the blade
The motor shaft is twisted
Turn off the motor and inspect
the mower. Get the mower
repaired by an approved
repair centre.
The motor stops
while mowing
The cutting height is too low
Raise the cutting height
The battery is discharged
Recharge the battery
TROUBLESHOOTING GUIDE
106
EN
