12
1. COOLERS:
It cools the amplifier. Install in a cool place being careful to
not obstruct the air vents.
2. INPUT:
Input of the signal to be amplified. Connect to the radio/player
using high quality shielded RCA cables to prevent unwanted noise.
3. GAIN:
Level control for the signal at the amplifier’s inpuat.
4. SUBSONIC FILTER
:
This variable control allows you to select the initial
frequency from
5Hz to 35Hz
that will be reproduced by the amplifier.
5. LOW PASS FILTER:
This variable control allows you to select the final
frequency from
35Hz to 250Hz
that will be reproduced by the amplifier.
6. BASS BOOST:
Fixed bass boost at 35Hz with adjustable actuation from
0 to +18dB
.
7. OUTPUT CONNECTOR (SPEAKERS):
MONO output of amplified signal
for speakers connection. Check the minimum impedance and polarities
before performing the installation.
2
4
3
7
1.
COOLER
1.
COOLER
5 6
Input, output and audio controls
