14
LED indicators
POWER (blue LED):
Indicates that the amplifier is on
when it is on.
PROT (top red LED):
Indicates that the amplifier
malfunctioned and entered protection mode, forcing
it to shut down. Use the
protection table below
to
find the possible problem and turn on the amplifier
on again.
CLIP (lower red LED):
Indicates that there is signal
distortion at the amplifier output.
Problem:
Short circuit or output overload.
Solution:
Make sure that the speaker cables are well
isolated.
Verify the minimum impedance supported.
Solution
:
Verify that the amplifier is in a well-ventilated
place and that the coolers are not obstructed.
Problem:
Overheating
Solution
:
Battery consumption is normal when using
the amplifier. Recharge the battery.
Solution:
Verify the power supply/battery system.
Problem:
Low battery.
Problem:
Tension higher than allowed.
Smart protection system
In the event of a problems, the amplifier will turn off and the
PROT LED
will flash. Depending on the problem, the led will flash a certain number
of times indicating the cause of the problem, as shown in the table below:
1 x
2 x
3 x
4 x
